Small Grove services, repairs and deep-cleans domestic air conditioning. Every job starts with a measured diagnosis and a written quote, so nothing is fitted or replaced before you have agreed to it.
Most call-outs fall into a handful of patterns. Read the row that matches before you book — it usually tells you whether this is a clean, a part, or a survey.
Low refrigerant pressure from a slow leak, or a condenser fan that is turning too slowly to shed heat.
Pressure test and leak trace before any top-up. A system that has emptied once will empty again if the leak is left.
Biofilm on the indoor coil and blower wheel, held damp by a drain tray that is not clearing properly.
Full deep clean of coil, wheel and tray, then a flush and fall check on the condensate line.
Blocked or back-falling condensate drain, or an iced coil melting faster than the tray can drain.
Clear and test the drain run, correct the fall where we can reach it, and find out why the coil iced up.
Fan bearing wear, a loose blower wheel, or outdoor unit mounts that have worked themselves loose.
Isolate the noise indoors and out, re-seat or replace the failing part, and re-check vibration afterwards.
Loaded filters, a dirty outdoor coil, or a unit that is undersized for a room that has since been extended or glazed.
Service the airflow path first, then measure the room and tell you honestly if the sizing is the real problem.
If the unit has tripped the breaker more than once, switch it off at the isolator and book a repair call rather than a service — repeated tripping is an electrical fault, not a dirty filter.
Each visit has a defined scope so you know what is covered before the engineer arrives, and what would be quoted separately.
The yearly maintenance visit that keeps efficiency and warranty conditions intact.
Not included: replacement parts, refrigerant charging, or work above safe ladder height.
For a system that has stopped, trips, leaks water or has lost its cooling.
Not included: parts on back order, or rebuilds we judge uneconomic against a replacement.
A strip-level clean for units that smell, or that have never been cleaned properly.
Not included: ductwork cleaning, or plaster and decoration repairs behind the unit.
A measured survey before you commit to a new unit or move an existing one.
Not included: structural alterations, scaffolding, or planning and freeholder consent.
A standard service takes about an hour for a single wall split, a little longer for a multi-split or a deep clean.
You get a note at the start of your window so nobody waits in all morning.
Running pressures, current draw and grille temperatures are taken while the system is still as you use it.
Sheets down, unit bagged where washing is involved, and everything cleared before we pack up.
What was measured, what was done, and what to watch over the next season — with a quote attached only if something genuinely needs attention.
Half of what keeps a system healthy is owner-side and takes minutes. The rest needs gauges. Here is the honest division.
Tell us the unit and the symptom and we will come back with a window, an expected duration and what the visit covers.